Tips to Do a Factory Reset to A LG LED TV

Tips to Do a Factory Reset to A LG LED TV

lg led tv

A LG LED TV, one of the most desirable and impressive television in the market today, requires constant attention and care from its owner. The device has a long working life but that also means that it could get faulty at anytime. Hence, it is very important to know how to carry out the maintenance and care routine on the unit. This will ensure a longer working life span for your television set. Some tips on taking care of your LED television are mentioned below.

 

First and foremost, you have to turn off the power at your television set and unplug it from the wall. This is to avoid any mishaps such as short circuits. You can also take the help of an appliance repair man to do this task for you. It is always better to take precautions than suffer in the event of a serious issue arising because you did not heed the warning signs that something could go wrong with your television.

 

Once you are done with this, you should take out the battery from the back of your LG LED TV. After this, you should remove the remote control that is still attached to the TV. In order to remove the remote from the back of the television, you should press and hold the control buttons on the remote for about two to three times. This is to release the screws that were holding the remote in place.

 

Next, you have to disconnect the power from your television set and turn on the power supply. In this process, you have to make sure that you release all the cables that were attached to the power supply previously. One by one, you have to remove the screws of your LG LED TV and separate it from its base. Note that if you have a vertical screen, you have to tilt it down before you can remove the TV from its base. Once you are done with this task, you have to place the TV on a flat surface so that you can easily lift and place it on a table or a stand.

 

The next step that you have to follow is to remove the LCD display. You have to do this by using the Phillips head screwdriver. In addition to this, you need to use the small Flat head screwdriver in removing the inverter. After this, you have to wait for the battery to be fully charged before reassembling it back.

 

The last step that you have to do is to remove the back casing from your TV. At this point, you can use the screwdriver and pliers in removing the two screws that are holding the back glass in place. Once you are done with this step, you should notice that the back glass has been removed already. Meanwhile, the inverter is located inside the TV. You can take out the inverter through the access hole provided on the back casing.

 

After you have removed the inverter, the wires from the back side of your TV can be found and connected with the wires from the previous steps. However, some wires will be visible. If you are not sure how to connect the wires, you can read the manual that comes along with your television. This will help you to reconnect the wires after you have detached the inverter.

 

Before installing the back panel, you need to turn off your electricity. Then, you can install the LCD LED TV by sliding the plastic tabs on the back. After this, you can plug in the cable of the television and then press the power button on the back to start the process. Usually, you will need at least six hours to complete the installation. After the process is completed, you can turn on the television.

Related Post

Leave a Reply

Your email address will not be published. Required fields are marked *